Danfoss VLT AutomationDrive FC 301 Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Accionamentos DC Danfoss VLT AutomationDrive FC 301. Danfoss VLT AutomationDrive FC 301 16 páginas. 24 v dc supply
Também para Danfoss VLT AutomationDrive FC 301: Manual de instalação (20 páginas), Manual de instruções de instalação (6 páginas), Manual de instalação (18 páginas), Manual de instruções de instalação (8 páginas), Manual de instalação (6 páginas), Manual de instalação (16 páginas), Manual de instalação (8 páginas), Manual de instruções de instalação (6 páginas)

Installation Guide | VLT® Programmable I/O MCB 115

2.3 Safety Precautions

UNINTENDED START

When the drive is connected to the AC mains, DC supply, or load sharing, the motor may start at any time, causing risk of death,

serious injury, and equipment or property damage. The motor may start by activation of an external switch, a fieldbus

command, an input reference signal from the LCP or LOP, via remote operation using MCT 10 Set-up software, or after a cleared

fault condition.

Press [Off] on the LCP before programming parameters.

Disconnect the drive from the mains whenever personal safety considerations make it necessary to avoid unintended

motor start.

Check that the drive, motor, and any driven equipment are in operational readiness.

LACK OF SAFETY AWARENESS

This document gives important information on how to prevent injury and damage to the equipment or the system. Ignoring

them can lead to death, serious injury, or severe damage to the equipment.

Make sure to fully understand the dangers and safety measures incurred in the application.

W A R N I N G

AN295938195323en-000101 / 130R0655| 7

Safety