Dune HD TV-303D Manual de início rápido - Página 12

Procurar online ou descarregar pdf Manual de início rápido para Leitor multimédia Dune HD TV-303D. Dune HD TV-303D 16 páginas.

English

Using USB 3.0 Slave Function

To connect the player with an installed internal HDD via USB 3.0 Slave, connect the USB 3.0 Slave port

of the player to the USB host port of the PC. The PC will recognize a new USB device. After finishing

working with the player in the PC, ensure the USB device is correctly stopped in the PC («Safely remove

hardware»or a similar function) and then disconnect the USB 3.0 Slave port of the player from the USB

host port of the PC.

To connect a network drive using SMB or NFS protocol, ensure you are on the main screen of the player

menu, press the "MENU" RC button, and choose "Create Network Folder", then fill the parameters of the

network drive as needed. The player will show an item corresponding to the configured network drive on the

main screen.

To browse the list of network resources accessible via SMB or UPnP protocols, use "Network Browser" item

on the main screen of the player menu.

NOTE: If some network resources are not shown by the player, you may need to wait some minutes and then

retry (or press the "MENU" RC button and choose "Refresh" command).

To format an HDD attached to the player, select the HDD item on the main screen of the player menu,

press the "INFO" RC button and choose "Format Disk" (to format the entire disk) or "Format Partition"

(to format an already existing disk partition only). The player will format the disk. To format an unformatted

HDD, just press the "ENTER" RC button on the HDD item.

NOTE: To use disks formatted by the player on a Windows PC, you may need to install additional software on

the PC, such as "EXT2FSD" (http://www.ext2fsd.com/).