Casio 2535 Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Ver Casio 2535. Casio 2535 5 páginas.
Imprimir página
How Stopwatch Data is Stored
The following table describes how data is stored when you perform the various button
operations described in "To measure times with the stopwatch".
Stopwatch Button Operation
A Start (from all zeros)
Creates a new log: current date and distance
(updated as timing progresses)
A Stop
Time measurement stops, without storing data in
memory.
A Re-start
Time measurement re-starts, without storing
data in memory.
D Lap/Split
Creates new record: displayed lap/split times
D Clear
Creates new record: displayed lap/split times
(Stopwatch display is cleared to all zeros.)
Backlight Precautions
The electro-luminescent panel that provides illumination loses power after very long
use.
The illumination provided by the backlight may be hard to see when viewed under
direct sunlight.
The watch may emit an audible sound whenever the display is illuminated. This is
due to vibration of the EL panel used for illumination, and does not indicate
malfunction.
The backlight automatically turns off whenever an alarm sounds.
Frequent use of the backlight runs down the battery.
Auto light switch precautions
Wearing the watch on the inside of your wrist and movement or vibration of your arm
can cause the auto light switch to activate and illuminate the display. To avoid
running down the battery, turn off the auto light switch whenever engaging in
activities that might cause frequent illumination of the display.
The backlight may not light if the face of the watch is
More than 15 degrees
more than 15 degrees above or below parallel. Make
too high
sure that the back of your hand is parallel to the ground.
The backlight turns off in about one second, even if you
keep the watch pointed towards your face.
Static electricity or magnetic force can interfere with
proper operation of the auto light switch. If the backlight
does not light, try moving the watch back to the starting
position (parallel with the ground) and then tilt it back
toward you again. If this does not work, drop your arm
all the way down so it hangs at your side, and then bring
it back up again.
Under certain conditions, the backlight may not light until
about one second after you turn the face of the watch
towards you. This does not necessarily indicate
malfunction of the backlight.
USER'S GUIDE 2535
Data Store Operation
5