Danfoss ECL Comfort 296 Manual de serviço - Página 11

Procurar online ou descarregar pdf Manual de serviço para Termostato Danfoss ECL Comfort 296. Danfoss ECL Comfort 296 16 páginas. Return temperature limitation
Também para Danfoss ECL Comfort 296: Manual do utilizador (12 páginas), Manual de instalação (20 páginas), Manual de instruções (8 páginas), Manual de instruções (16 páginas), Manual de instruções (10 páginas), Manual de instalação (16 páginas), Manual de instalação (16 páginas), Manual de instalação (16 páginas), Manual de instalação (20 páginas), Manual de instalação (12 páginas), Manual de instalação (16 páginas), Manual de instruções (8 páginas)

Service guide

Site 1

Common signal shorted with PE (protective earth)

BUT common signal must be connected to earth ONLY ONE POINT (section 5 point 5).

So use "PT 1X2 +F-BE" and avoid "PT 1x2-BE".

8.2 Surge protector wiring

The correct wiring is equally important to get the best "surge protec-

tion in the network level.

The "gas discharge tubes" (between pin 7, 6 to 9 in the juxtaposed

example) is capable of handling higher surge current, but this device

is slow responding.

The "transils" (between pin 8 to 12 and 10) are capable of handling

low surge current, but very fast responding. These two sets of com-

ponents (gas discharge tubes and transils) are separated by a resistor

which forces the surge to be first suppressed by the gas discharge

tube and the residue will be suppressed by the transil in the proper

installation ("field cables" to "gas discharge connection points" and

"electronics to be protected" are connected to "transil connection

points").

Refer the juxtaposed drawing for example.

• Odd numbered connection of PT 1X2+F-BE meant for outer filed

cables (both IN and OUT cable wires of field cable)

• Even numbered connection of PT 1X2+F-BE meant for repeater/

ECLs wires (both IN and OUT cable wires of ECLs / repeaters)

"Base part and surge protector data sheets must be referred before

making connection".

VI.LV.H1.02

ECL 296 / ECL 310 Modbus

Cable to next house

PT 1x2-BE

Site 2

Common signal shorted with PE (protective earth)

PT 3-PB-ST and PT 1X2+F-BE logical drawing:

3-wire, PROFIBUS (up to 12 MHz)

Total width 17.7 mm

PT 1x2-BE