Abus TVAC15010C Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Câmara de segurança Abus TVAC15010C. Abus TVAC15010C 14 páginas.
Imprimir página
7. Wireless transmission
The range of wireless transmission depends on various environmental factors. The local conditions at the
installation location can have a negative impact on the range. For this reason, if there is a clear line of
sight between the receiver and the transmitter, the range can be as much as 490 feet, but in buildings it is
significantly less.
The following environmental factors impair both the range and the frame rate:
Mobile phone towers, high-tension electricity pylons, power lines, ceiling and walls, devices with the same
or similar radio frequency.
Disclaimer
ABUS USA LLC. products are not manufactured and/or sold with the intent to be used for
compliance with all local, state and federal law. For further information on video
surveillance and audio recording legal requirements, please consult your local, state and
federal law. It is your responsibility to be aware of the local, state and federal regulations
regarding image storage and use.
Warnings
Follow all safety and operating advises before starting-up the device!
1. Follow these directions in order to avoid damage of the power cord or plug:
Do not modify or process the power cord or plug arbitrarily.
Make sure to disconnect the power cord holding the plug.
Keep heating appliances as far as possible from the power cord in order to prevent the cover
vinyl from melting.
It is only for indoor usage.
2. Follow these directions. Failure to follow any of them may cause electrical shock:
Do not open the main body or the power supply.
Do not insert metal or inflammable objects inside the product.
In order to avoid any damage during lighting use a surge protection.
3. Do not use the product when it is out of order. If you continue to use the product when defective, serious
damage can be caused to it. Make sure to contact your local product distributor if the product is out of
order.
During the installation into an existing video surveillance system make sure that all devices are
disconnected from the low and supply voltage circuit.
If in doubt allow a professional electrician to mount, install and wire-up your device. Improper
electrical connection to the mains does not only represent at threat to you but also to other
persons.
Wire-up the entire system making sure that the mains and low voltage circuit remain separated
and cannot come into contact with each other in normal use or due to any malfunctioning.
Avoid using the device under the following unfavorable ambient conditions:
moisture or excessive air humidity
extreme cold or heat
direct sunlight
dust or combustible gases, vapors or solvents
strong vibration
strong magnetic fields, such as those found in the vicinity of machinery or loudspeakers
the camera must not be directed into the sun as this can destroy the sensor.
the camera may not be installed on unstable surfaces
of these products to be in
rotected against humidity and damp.
6
English