DUO-FAST DF150-CS Manual de instruções e esquema - Página 7

Procurar online ou descarregar pdf Manual de instruções e esquema para Ferramenta eléctrica DUO-FAST DF150-CS. DUO-FAST DF150-CS 16 páginas. Cap stapler

Imprimir página

TOOL OPERATION -

continued

Triggering Selection

The tool is equipped with a trigger that can be switched

from sequential operation to bounce drive operation.

To switch the trigger, push the red lever inside the

trigger to the side and rotate it up or down until it locks

into the desired position.

The indicates that the tool is in the sequential position

and the

indicates the tool is in the bounce drive

position.

Sequential Operation

The sequential trigger position prevents succesive or "bounce"

driving.

Depress the work contacting element and hold it against the

■

work surface before pulling the trigger.

After each fastener is driven, completely release the trigger

■

and lift the tool from the work surface.

Successive (Bounce) Driving

Sequential

Drive Position

Grasp the handle ﬁrmly.

■

Squeeze the trigger and move the tool along the workpiece

■

with a bouncing motion, depressing the work contacting element

at the points where you want to insert a fastener.

Keep the trigger depressed and continue to bounce the work

■

contacing element against the workpiece, positioning the tool

above as carefully as possible.

When the desired number of fasteners have been driven,

■

release the tool trigger to avoid unintentional fastener discharge.

Precision Placement Driving

Grasp the tool handle ﬁrmly and place the bottom of

■

the work contacting element firmly against the work-

piece until it is completely depressed.

Squeeze the trigger to drive the fastener.

■

Lift the tool from the workpiece.

■

Repeat the procedure for the next fastener.

■

Successive (Bounce)

Drive Position