Free The Tone PA-1QA Manual do Proprietário - Página 4
Procurar online ou descarregar pdf Manual do Proprietário para Stereo Equalizer Free The Tone PA-1QA. Free The Tone PA-1QA 9 páginas. Programmable analog 10 band eq graphic equalizer
Também para Free The Tone PA-1QA: Manual (16 páginas), Manual de início rápido (2 páginas), Manual do Proprietário (6 páginas)
Imprimir página
The PA-1Q series can use up to 99 presets that can be recalled in various ways.
Switching between presets 1-4
1. Press the ON/OFF switch to turn on the LED above it.
2. Press the PRESET switch to switch the presets.
NOTE
Each press of the PRESET switch changes the presets as follows: PRESET 1
PRESET 1, ...
→
PRESET 4
Switching between presets 1-99
1. Press the ON/OFF switch to turn on the LED above it.
2. Press the PRESET tact switch to flash the PRESET display.
3. Turn the PARAMETER encoder to show the preset to be recalled.
4. Press the PARAMETER encoder to recall the selected preset.
Switching presets via MIDI
1. Connect an external MIDI controller to the MIDI IN terminal on the PA-1Q series rear panel.
2. Press the PA-1Q series ON/OFF switch to illuminate the LED above it.
3. From the external MIDI controller, send the MIDI program change number corresponding to the preset to be
recalled.
NOTE
Be sure to set the same MIDI program change number on the sending device's MIDI channel and the PA-1Q series
MIDI channel.
P.7
→
Setting a MIDI receiving channels
Correspondence between presets and MIDI program change numbers → P.8
6
Recalling a Preset
PRESET 2
→
→
PRESET 3
1. Press the ON/OFF switch to turn on the LED above it.
◀▶
2. Press the
cursor key switch to select the parameter to be adjusted.
3. Turn the PARAMETER encoder to adjust the selected parameter.
4. Press the SAVE switch.
5. The LEVEL display shows the destination preset number.
6. Turn the PARAMETER encoder to select the desired preset number.
7. Press the PARAMETER encoder to store the preset to the selected numbered location
→
NOTE
When a preset's parameter is changed, the dot at the PRESET display's lower right corner illuminates. This dot
turns off when the save operation is confirmed by pressing the PARAMETER encoder and the parameters are
written to the preset.
If the SAVE switch is pressed again after pressing it, then the write operation is canceled.
The PA-1Q series can receive MIDI signals sent from an external controller to switch presets and edit
parameters.
Setting a MIDI receiving channels
1. Turn on the power to the PA-1Q series while holding down the PRESET switch.
2. The PRESET display shows "
3. The LEVEL display shows the number of the MIDI receiving channel.
4. Turn the PARAMETER encoder to show the desired MIDI receiving channel.
5. Press the PARAMETER encoder to confirm the selected MIDI receiving channel.
NOTE
User editable parameters: ALL (Omni mode), 1–16 (MIDI receiving channel), OFF
Changing/writing preset contents
Configuring MIDI settings
ch
".
7