Duomo HCF100 Funcionamento - Página 5

Procurar online ou descarregar pdf Funcionamento para Detectores de gás Duomo HCF100. Duomo HCF100 8 páginas. Duct refrigeration gas sensor

Sensor Positioning

The HCF100 sensor should be mounted in accordance

with certain considerations. Do not position next

to burners, heaters or ovens where temperatures

above the room ambient may be experienced. It is, if

possible, better to mount the sensors on the opposite

wall. This is, of course, dependant on the size of the

protected area.

Freon R134a is heavier than air, therefore the

HCF100 sensor should be mounted 30cm from the

lowest point on floor of the protected area.

If you require assistance regarding locating sensors

please call our Droitwich factory on (01905) 797989

Important Notes

Always check the wiring before powering up the system.

When replacing sensors never seperate a sensing head from its PCB. The sensor will have been calibrated using this

particular board and therefore will not function correctly with any other.

Do not test this sensor with anything other than Duomo test gas. Concentrations above this will damage the sensor and

shorten sensor life.

The installation of this gas sensor does not release the user from observing all the regulations concerning the characteristics

of the installation and use of gas appliance, the ventalation of the protected environment and the removal of the products

of combustion. Duomo (UK) will not be held responsible or liable for any damage caused to people, property or animals

resulting from incorrect connection, installation or application of this gas sensor.

To ensure correct function after installation Duomo provide a commissioning service using calibrated test gases. For this

service call +44 1905 797989.

t: 01905 797989

e: [email protected] | w: www.duomo.co.uk

Freon