AudioControl LC7 Manual - Página 9

Procurar online ou descarregar pdf Manual para Conversor de multimédia AudioControl LC7. AudioControl LC7 16 páginas.

Ground Connection: Use the same gauge wire as you did for the

positive connector and run it from the "Ground" connector on your LC7

to the negative terminal of the battery, a ground bus, or a verified ground

location. The factory head unit ground is not a good ground!

Remote In: Your LC7 is equipped with GTO signal sensing which al-

lows it to turn on when it detects a signal at the Main speaker-level inputs

so you may not need to use the "Remote In" feature. Connect a 22 to 18

gauge wire from the source unit's remote turn-on or other trigger to the

Remote connector on the LC7.

Remote Out: If you are going to use the LC7 to turn on any external

signal processors or amplifiers, connect an 18 to 22 gauge wire from

the Remote Out on the LC7 to the remote turn-on of the processors or

amplifiers. Depending upon how many external devices you are turning

on, you may need to connect this wire to a relay and route 12 volts from

another source.

Once the electrical connections are complete, you will want to re-

connect the negative terminal to your battery. However continue to act

positively!

LC7 Audio Wiring

The LC7 needs to be installed in the signal path after your factory

source unit or amplifier but definitely before your aftermarket amplifiers

and/or any signal processors. You may already have guessed there are

numerous ways to configure the LC7 in your audio system so we recom-

mend you spend a little quality time planning out your system and even

sketching it out on paper.

Interfacing with factory-installed radio

Figure 5: LC7 system using summing functions – 2-way front plus subwoofer

page