AudioControl LCQ-1 Manual de instalação rápida - Página 2
Procurar online ou descarregar pdf Manual de instalação rápida para Conversor de multimédia AudioControl LCQ-1. AudioControl LCQ-1 10 páginas. Six channel line output converter with multi-channel equalization and accubass
Imprimir páginaone of two people, someone with perfect
pitch, "golden ears" (these are very rare) or a
person with a great deal of tuning experience.
A Real Time Analyzer (RTA) is a great tool to
have at this point as well. An RTA reads the
audio response in your car and displays it visu-
ally so your AudioControl dealer can quickly
and accurately tune your LCQ-1 to give you
the best possible sound in your car.
Figure 1. Basic system using Factory Radio. (If the factory stereo does
not have a sub out, the LCQ-1's AutoMode circuit will give you one) front rear need to be
full range.
Figure 2: Factory Radio with remote mounted factory amplifier. Signals are summed
inside the LCQ-1.
AudioControl Real Time Analyzer
A Guided Tour of LCQ-1
Speaker-level Inputs: The LCQ-1 has six speaker-level inputs. These
inputs get their signals from the speaker-level outputs of your factory-
installed source unit or amplifier. If your source unit has front, rear, and
subwoofer speaker-level outputs, connect them to the three sets of inputs
on your LCQ-1. If the source unit only has front and rear outputs, the Auto
Mode circuitry in your LCQ-1 automatically routes the Channel 2 input
channels to the (Channel 3) subwoofer channels.
Equalizer Controls: To custom tune your system, the LCQ-1 gives you
dedicated equalization controls for the Front, Rear, and Subwoofer outputs.
AccuBASS™: The Threshold and level controls let you determine when
the AccuBASS™ circuit starts bass correction and the level of correction
applied. (See page 8.)
Ground: Connect to a good, verified chassis ground (the battery comes to
mind.) Warning: Factory ground wires already have multiple devices con-
nected to them and are not recommended.
+12V Power: Connect to a good source of 12-volt power (the battery
comes to mind again).
Remote In: In some unusual installations, you may not want to use the
GTO™ to turn on your system. For these cases the LCQ-1 can be turned
on remotely with a +12-volt trigger. When you use the +12-volt remote in,
you can set the internal GTO™ jumper (see "Under the Covers" below) to
"Defeat". This will prevent the car's computer from turning the system on
unexpectedly.
Remote Out: Outputs 12 volts when the LCQ-1 is powered up, so you
can turn on external devices like signal processors and amplifiers.
Maximized Indicator: This brightly colored LED indicates when the
signal level is just below clipping your LCQ-1. When properly level
matched, this LED should flicker occasionally when your system is play-
ing at its maximum volume level.
Power: If you have connected all of your power wires correctly, this light
should be bright red when your system turns on.
Optional (ACR-2) Dash Mounted Control: You can add a multi-func-
tion dash control that allows you to set the level of the subwoofer. It also
has an in/out switch for the equalizer function so you can hear the system
before and after your tuning changes. Simply tap in the remote knob to
compare the sounds.
page 2