Danguard HS-400 Manual do utilizador - Página 3

Procurar online ou descarregar pdf Manual do utilizador para Sistema de segurança Danguard HS-400. Danguard HS-400 17 páginas.

4. Operation

1. Connect the camera to the power supply. The power Indicator on the back is turned on.

2. Connect the receiver to the power supply.

3. Press the power switch

on the receiver for 2s. or press the power switch

control (direct the remote control toward the receiver). The power indicator is turned on and the

power-on picture appears.

4. Pair the cameras and receiver respectively (at most four cameras can be connected at the same

time). Pairing is completed by default before delivery. If pairing is not completed, complete pairing

according to "Pairing" on page 18.

on the remote

ENGLISH

4. Operation

5. After successful pairing, the following real-time monitoring picture appears:

Picture display area

Time stamp

2013/11/15/09:30

Picture display area

2013/11/15/09:30

6. Press the button

to switch between four display modes:

four pics

one big,

three small pics

7. Press the

button to enter cyclic mode display. Five cyclic intervals are available: 5s, 10s, 15s,

20s, and 30s and can be set under "System".

Meanings of icons on the real-time monitoring picture:

Mobile hard disk inserted successfully

SD card inserted successfully

No open router

Network connection failure

Network connection successful

Picture display area

2013/11/15/09:30

Picture display area

2013/11/15/09:30

one pics

one big,

three small pics

Current camera

Recording status

Signal intensity

Camera name

Mute

ENGLISH