AUDIOLINE Baby Care 1 Manual de Instruções - Página 16

Procurar online ou descarregar pdf Manual de Instruções para Monitor de bebé AUDIOLINE Baby Care 1. AUDIOLINE Baby Care 1 20 páginas.

Operation

4.1

Position the baby unit near to the baby. Please observe the minimum distance of one metre. For best

transmission, the integral microphone (6) should be pointing towards the child.

Now select one of the two channels A or B with the channel switch (3).The parent and baby units must

be set to the same channel.

Switch on the baby unit by moving the slide switch (1) to the ON position. The baby unit is now ready for

use. In the ON position, the baby unit is always in operation. The in-built microphone will continuously

transmit any noises made by your child.

You can switch the night light on and off by means of the Night light button (5).

In battery mode, the indicator light (4) shows green when there is sufficient battery capacity. You should

change the batteries if the indicator light shows red. When used with the power supply, the indicator light

always shows red.

To switch off the baby unit, move the slide switch (1) to the OFF position.

Reducing radiation/Battery saving mode

Move the slide switch (1) to the AUTO position. With this setting, the baby unit will only transmit when

noises are received. This reduces radiation, as the baby unit will only transmit when the baby makes a

noise. Furthermore, in battery mode, the life of the batteries will be increased.

Note:

Check that both units are working properly each time before using.

When using the AUTO function, check whether the noises made by the baby are loud enough to initiate

a transmission.

4.2

Position the parent unit near to you. The parent unit has a rotating belt clip. If the belt clip is turned

downwards, you can place the parent unit on a flat surface. If the belt clip is turned upwards, you can fix

the parent unit to your belt and thus have it with you at all times. You can also hang up the parent unit in

any convenient place using the clip.

Now select one of the two channels A or B with the channel switch (8).The parent and baby units must

be set to the same channel. Switch on the parent unit by turning the slide switch (7) to the ON position.

The parent unit is now ready for use. Set the required volume with the slide switch (7). The volume

becomes louder in the ON direction and reduces in the OFF direction.

In battery mode, the indicator light (10) shows green when there is sufficient battery capacity. You should

change the batteries if the indicator light shows red. When used with the power supply, the indicator light

always shows red.

To switch off the parent unit, move the slide switch (7) to the OFF position.

- Operation -