DANIU QY-EWQ-01 Manual - Página 6

Procurar online ou descarregar pdf Manual para Termómetro DANIU QY-EWQ-01. DANIU QY-EWQ-01 16 páginas. Infrared forehead thermometer

Picture 4:

■ Battery installation and replacement:

1) After the battery cover is opened, place the battery in the direction of the positive and negative

electrodes, and pay attention to the direction of the positive and negative electrodes.

2) Please replace the new battery while low battery alarm, press (Figure 4) to open the battery

compartment cover (see product structure ⑨), pay attention to the positive and negative polarity

when replacing the new battery. Noted that improper placement may damage the products or

batteries.

3) If you do not use it for a long time, better to remove the battery to extend the life to prevent

damage to the thermometer due to battery leakage.

2. Button description:

1): Calibration mode: After removing the battery, press and hold the + key and the function key to

power on lasting 5S. After hearing 2 beeps, press the-key to enter the calibration mode. Take the

numbers in sequence, complete the calibration, and then switch to the object temperature

measurement mode for temperature verification.

2): Power-on key: Press and hold the switch / function key for 3 seconds to power on / off,

3): Power on, enter the screen self-test, the end of the beep reminder, and enter the ambient

temperature display.

4): Temperature measurement key: short press, the collected temperature will be displayed on the

screen within 1 second, and the current test record will be kept before the next action.

5): Function key

● Short press the first time to switch between body temperature and surface temperature mode.

● Press and hold for 3 seconds to enter the setting mode:

a. F1 state, for F and ℃ mode switching selection, press +,-to switch;

b. Short press again, F2 status is for adjusting the temperature of high temperature alarm, press +,-to

adjust the temperature to be alarmed;

c. Short press once again, F3 state, for the display data offset setting, press +,-to adjust the value to

be offset displayed;

d. Short press once again, F4 state, for the buzzer sound switch setting, press +,-to adjust the true

sound switch;

● In the power-on state, press the +/- key: In order to enter the temperature measurement view

6 / 16