AudioMX HG-21B Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Auscultadores AudioMX HG-21B. AudioMX HG-21B 8 páginas. Digital over-ear headphones

Headphones battery installation

1. Hold the rear of the headphones and gently screw the right ear cushion in an

anticlockwise direction.

2. Insert the supplied two micro AAA / HR03, 1.2V, batteries into the battery compartment

with correct polarity.

3. Place the ear cushion back on the headphones by screwing it in a clockwise direction.

Operation

Using the transmitter and headphones

1. Turn on the audio source which the transmitter is connected to.

2. Turn on the headphones by pressing the power button on the left ear piece for about

1 second. The LED indicator on the headphones will light up in red until a remote

connection is established with the transmitter. The LED changes to green permanently

when a connection has been established and the audio signal is transmitted.

3. Place the headphones on your head. To obtain the desired sound level, adjust the volume

control on the headphones. An acoustic signal will alert you to a high volume setting.

4. When the battery power of the headphones becomes too low, the LED indicator on

the headphones changes to red. A warning tone can be heard every minute. After two

continuous alert tones, the headphones will automatically turn off. You will need to

recharge the headphones before you can use them again.

5. The headphones can be used as regular wired headphones by connecting your audio

source to the headphones directly.

Notes:

1. If the transmitter does not receive any audio signal for 5 minutes, the operating LED of the

transmitter turns off.

2. The LED indicator on the headphones will light up red if no transmitter is within range.

3. The headphones will automatically switch off if there is no signal from the transmitter for 5

minutes.

Charging the headphones battery

1. Turn off the headphones by pressing the power button before charging. This may avoid

battery damage.

2. Place the headphones onto the cradle of the transmitter. Make sure the charging pins on

the transmitter and charging contacts of the headphones are matched.

3. The charging LED on the transmitter will light in green during charging and go out when

charging is completed.

Notes

1. To ensure a longer service life, fully charge the batteries for 7 hours before using the headphones

for the first time.

2. When the charging station is switched off, the batteries will not be charged.

Cautions

1. Never attempt to recharge conventional dry cells (batteries).

2. Do no expose the batteries to excessive heat such as direct sunshine, fire or the like.