Audionet Amp I V2 Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Amplificador Audionet Amp I V2. Audionet Amp I V2 18 páginas. Stereo audio power amplifier

Imprimir página

Inputs and outputs

Important

For connecting or removing loudspeakers and/or the pre ampli-

fier your AMP1 V2 must be switched off to prevent damage to

the amplifier or the connected units.

Please make sure that all cables are in absolute best conditions!

Broken shields or short-cut loudspeaker cables could damage

speakers and/or amplifiers.

5.1 Inputs

The AMP1 V2 has two RCA inputs 1 and 8 for the connection of a pre

amplifier, e.g. Audionet PRE G2. Due to the dual mono construction, left

and right inputs are separated at the rear.

Please connect the right 1 and left input 8 of the AMP1 V2 to the cor-

responding outputs of your pre amplifier.

5.2 Speaker terminals

Connect your speakers to the gold plated terminals 2 and 7 on the back

panel of the AMP1 V2. You can use banana plugs or spades as well as

simple cable ends. In case you would like to bi-wire your speakers please

refer to section 'Bi-Wiring' on page 11.

Note

Look out for the correct connection of your speaker cables. Usually,

the terminals of your speakers are marked '+' and '-'. The AMP uses

the same marks.

Wrong speaker polarization will result in severe loss of sound quality!

Important

Although the AMP1 V2 has an effective protection system to pre-

vent damage to the circuits, switch off the unit while working on

the speaker and/or audio cables.