Danner PONDMASTER HAMPTON CPF2000U Instruções de utilização e cuidados - Página 5

Procurar online ou descarregar pdf Instruções de utilização e cuidados para Sistemas de filtragem de água Danner PONDMASTER HAMPTON CPF2000U. Danner PONDMASTER HAMPTON CPF2000U 11 páginas. Pressurized filter system

Imprimir página

PUMP AND TUBING

CHOOSING THE CORRECT PUMP

Your Pressurized Filter System works best within a certain range of flow. See Table below. Exceeding these

values will cause leakage or breakage of the filter or its components and void the warranty.

PRESSURE FILTER

MODEL

CPF250/PF225

CPF500/PF450

CPF1000/PF900

CPF2000/PF1900

Note that the hose fittings of your pressure filter vary depending on your model. Be sure to check the fitting

sizes on the pump you choose and pick up the necessary adapters.

Choose a pump that does not exceed the recommended output for your pressure filter. Danner Manufacturing

produces a variety of pumps to choose from for your set-up. See our website and/or your dealer for a selection

of Pondmaster, Hampton Water Gardens and Supreme pumps.

Note that head height, length and diameter of hose and fittings all add to back pressure that can

overburden your pressure filter or lead to low water flow. To maximize your system do the following:

Avoid using more tubing than is necessary for your filtration set-up.

Use tubing with a diameter that is equal or greater than the intake and output ports of the filter.

Keep tubing as straight as possible to avoid kinks.

elbow connectors add to back pressure and should be kept to a minimum.

Use a bypass valve to bypass the optimal flow of water to the filter, allowing excess flow and pres-

sure to return directly back to the water feature.

ELECTRICAL PRECAUTIONS

Always use a properly grounded outlet. Do not immerse the plug in water. DO NOT REACH INTO THE WATER

TO REMOVE THE PLUG. TURN OFF CIRCUIT FIRST. A "drip loop" in the cords should be used. A "drip loop" is a

loop in the cord below the level of the receptacle or plug that prevents water from traveling along the cord.

The national Electric Code requires that a ground fault interrupter circuit (GFCI) be installed in every branch

circuit supplying the fountain or pond equipment. Your dealer can supply GFCI units. NEVER REMOVE

GROUND PIN FROM PLUG.

WARNING: FOR YOUR PROTECTION, ALWAYS UNPLUG THE UNIT FROM ITS POWER SOURCE BEFORE INSTALLING

OR SERVICING. DO NOT REACH, REMOVE OR DISASSEMBLE BEFORE YOU DISCONNECT POWER.

IMPORTANT INFORMATION!

MAXIMUM PUMP

OUTPUT (GAL/HOUR)

500

950

1200

1800

INTAKE PORT

OUTLET PORT

3/4"