aevit DIGIPAD II Manual de instalação - Página 4

Procurar online ou descarregar pdf Manual de instalação para Sistema de vídeo para automóvel aevit DIGIPAD II. aevit DIGIPAD II 7 páginas. Power headrest

Imprimir página

Preparing the Vehicle

Begin by fitting the driver to the driving compartment which includes installing all tiedown restraint systems.

When complete, remove all plastic or metal mouldings around the upper door opening and rearward of the

"B" pillar on the side wall header panel. You may have to remove the shoulder strap retaining bolt in order to

remove the molding. Do Not mount the Power Headrest Base on top of mouldings for any reason!

Power Base Fitting & Mounting

When installing the Power Base Unit, position it such that it is behind the driver's head and does not interfere

with the seat belt system. Remove the ABS plastic protective cover from the Power Base by removing the

#8-32 machine screw as depicted in the diagrams. Once the position is determined, temporarily screw the

unit to the header panel with two (2) self-tapping screws. Drill the remaining two (2) mounting hole positions

through the header panel using a 5/16" drill. Insert the expanding bolts provided. While holding the bolt with

a 5/8" box wrench, tighten the 5/16" bolt head while applying inward pressure against the wall header panel

until tight. Remove the temporary self-tapping screws and drill and replace with expanding bolts. All four (4)

expanding bolts need to be used when mounting the Power Base to the vehicle!! Replace the protective ABS

plastic cover over the Power Base unit and secure with the #8-32 machine screw.

Always remove the plastic header panel molding and mount the Power Base directly to the header sheet

metal. NEVER mount the Power Base to plastic moldings or use self-tapping screws.

Expanding Bolt (4)

ABS Plastic Power Base Cover & Screw

Headrest Fitting & Mounting

The Power Base contains a 1-piece Adjustment Arm that receives the ball shaft of the molded headrest pad.

The length of the ball shaft is such that it allows for linear and rotational adjustment to fit most drivers. Make

certain that all six (6) setscrews lock against the shaft to prevent unwanted movement.

This headrest rotates 90 degrees but requires no lubrication. When installing the pad on a Power Headrest-1 or

-6, make sure that the telco cable does not interfere with the rotational motion of the adjustment arm.

To install the headrest, slide the Headrest stainless steel Ball Shaft into the adjustment arm receiver of the

Power Base and tighten the six (6) setscrews to lock in position. Rotate the Headrest pad to the desired angle

and securely tighten the three (3) socket head attachment bolts to lock into position. Do not remove the

molded plastic shell on the back of the Headrest Pad! Once final positioning is determined, go back and check

all setscrews and securement bolts for tightness. This unit will only perform well if installed properly. Make

sure there is no binding!

Installation

Safety Shear Bolt

Adjustment

Arm

Setscrews (6)

Ball Bearing

Floating Hinge