Addonics Technologies DCDCS256U Manual do utilizador - Página 3

Procurar online ou descarregar pdf Manual do utilizador para Armazenamento Addonics Technologies DCDCS256U. Addonics Technologies DCDCS256U 4 páginas. Diamond cipher aes 256-bit drive cartridge system

Imprimir página

Step 4

Turn the Diamond enclosure over with

the hard drive mounting holes facing

up. Use the included flat head screws

to secure the hard drive onto the

bottom of the enclosure and turn in

the screw to the "LOCK" position.

Powering On the Drive Cartridge System:

Note:

Be sure the Diamond cipher key is inserted into the drive enclosure prior

to turning on the power of the drive cradle. The hard drive will not be

detected by the computer if the power to the drive cradle is turned on

without the Cipher key. Under such condition, the power on the drive

cradle will have to be turned off and turned back on again with the

Cipher key already inserted into the drive enclosure in order to detect

the hard drive.

Power Switch:

To power on the enclosure, use the key provided to turn the locking mechanism

on the drive cradle into the Lock position. When the switch is turned on, the

green LED located on the left side of the drive cradle would light up to indicate

power. The encryption key LED will also light up. The amber LED will blink if

there is drive activity.

Note:

There are no drivers needed to use the eSATA cable as long as the

drivers are installed for the Serial ATA Controller card/chip. It is plug

and play.

Brand new hard drive must be partitioned and formatted first before a

drive letter is assigned by the OS. When a hard drive with data on it is

formatted with the Diamond cipher all the data will be erased.

Once the drive is detected by the system OS, the Diamond cipher key

may be removed from the drive enclosure. The encryption key LED will

turn off but the Diamond Cipher hard drive will continue operating

normally (encrypting) till it is removed from the system or powered off.

Cable Connections

Model: DCDCS256S

Power: Use either the 4-pin Molex or the 15-pin SATA power connector.

Do not use both power sources simultaneously.

Data:

Connect the SATA cable to the SATA connector located at the back of the drive

cradle and the other end to the SATA connector on your SATA host controller or

onboard SATA port.

LED cable: Only needed if you want to get drive access signal from the SATA

controller. Use the LED cable to connect the LED pin located at the back of the

cradle (beside the LED switch) to the LED jumper pins on your SATA host

controller or onboard SATA port to enable the drive activity LED.

Factory default, LED signal coming from hard drive.