aevit 2.0 Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Suporte para TV aevit 2.0. aevit 2.0 17 páginas. Mounting brackets

prIMArY INpUT

2.3 MOUNTINg BASE INSTALLATION - dOOr

(CONTINUEd)

sTEP 1

Remove the driver's door panel and mark

the area where the Door Base Plate will be

mounted. See hole diagram on previous

page. Mount the door plate with no less than

(5) 1/4-20 x 1" bolts and locknuts. After the

plate is mounted, mark and drill (4) 5/8" holes

for the standoffs.

sTEP 3

you may need to use other tools to remove

the carpet on the other side of the panel.

(BrkT-AEVIT-dOOr)

sTEP 2

Once the holes are drilled, cut away any

plastic areas that will interfere with the door

plate being mounted parallel with the door.

Be sure that the areas that were cut away

remain neat.

sTEP 4

your mounting system comes with (4) spacers that

can be cut to any length to bring the Upper Pole

Mounting Plate out from the door, depending on the

vehicle.

NOTE:

ThE (4) 5/16 x 3" hEx hEAD BOLTS ARE LONG ENOUGh

FOR USE WITh ThE SPACERS AT FULL LENGTh. IF yOU CUT

ThE SPACERS, hOWEVER, YOU wILL NEEd TO prOVIdE

A SMALLEr BOLT ThAT WILL OFFER AT LEAST 1/2" OF

ENGAGEMENT INTO ThE DOOR BASE PLATE BOSSES.

AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL

2-4