aevit VIC 2.0 Manual de instalação e operação - Página 8

Procurar online ou descarregar pdf Manual de instalação e operação para Unidade de controlo aevit VIC 2.0. aevit VIC 2.0 17 páginas. Voice interactive controls

Imprimir página

VIC 2.0 INSTALLATION

3-3

INSTALLATION STep 5

Connect the Radio Defeat Harness to the VIC 2.0 CPU

RD port and route the harness to the vehicle's radio.

All digital radio systems contain two 12VDC power

feeds. One of these wires is always "hot" and is used

to maintain the radio's memory. The other power feed

wire should be the "switched ignition radio activation

wire", which turns the radio system on.

The switched ignition radio activation wire, NOT THe

MAIN rAdIO pOwer wIre, will need to be cut and the Radio Defeat harness should be wired on

either side of this cut as shown in the figure below. dO NOT CUT THe MAIN rAdIO pOwer wIre

BeCAUSe IT wILL LOSe THe SeTTINgS FOr THe rAdIO. To locate the switched ignition radio acti-

vation wire, simply test for the wire that reads +12VDC when the vehicle's ignition is turned on and

0VDC when the ignition is turned off.

CAUTION:

DO NOT CUT THE MAIN BATTERY POWER TO THE RADIO BECAUSE IT WILL LOSE THE SETTINGS.

MAKE CERTAIN THAT THE OEM WIRE USED IS THE SwITCHED IgNITION RADIO ACTIVATION wIRE.

wARNINg:

THE RADIO DEFEAT CIRCUIT WITHIN THE VIC MODULE IS FUSED TO 5A. USE CAUTION WHEN SE-

LECTING THE APPROPRIATE OEM WIRE.

� � � � � � �

� � � � � � � � � � � � � � � � � � � �

� � � � �

� � � � � � � � � � � � � � � � �

� � � � � � � � � � � � � � � �

� � � �

VIC 2.0 INSTALL MANUAL