audiophony SX15A Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Sistema de altifalantes audiophony SX15A. audiophony SX15A 8 páginas. 12/15 inches 2-way amplified speakers with bass reflex
Imprimir páginaENGLISH
SX12A/SX15A input setting
1 - Connect the loudspeaker to the mains via IEC plug / 2-pin + earth. Leave the power switch in the OFF position.
2 - Set the MASTER potentiometer to the - position.
3 - Connect your microphone or line level source or both. The line input can be accessed via a 3-pin 6.35 mm (TRS) jack and
RCA LINE IN. To acces to the microphone preamplifier, use the XRL plug
4 - Switch on the line level source.
5 - Switch on the SX speaker.
6 - While you are speaking in a microphone or an audio signal is being played from your line-level source, turn the input
MASTER knob until the LIMIT LED lights up in red, then turn it down just below that level.
7 - If you use a microphone, be careful not to stand too close to the speaker as this may result in feedback.
6 - Principle diagram
Typical use
Page 6
SX12A / SX15A - 2 way bass reflex 12/15" powered speakers
Line cord
Mixer
Line cord
Left and right
master outputs
of the mixer