Dansing Wings SCG37 Manual de instruções - Página 5
Procurar online ou descarregar pdf Manual de instruções para Brinquedo Dansing Wings SCG37. Dansing Wings SCG37 8 páginas.
Imprimir página细节2
Detail 2
03-14
03-15
Epoxy glue
Epoxy glue
上下机翼间安装支撑件，调整机翼平直后用环氧胶粘固，左右相同安装。
Install supports between the upper and lower wings. After adjusting
the straightness of the wings, glue them with epoxy glue, and install
them the same on the left and right.
在图中位置安装螺丝。
Install the screws in the
position shown in the figure.
7
x2
03-16
螺丝 Screw+螺母 Nut
M2*11mm
03-17
螺丝 Screw+螺母 Nut
M2*11mm
04
方向舵舵机及连杆安装
Install the rudder steering gear and connecting rod
04-1
螺丝 Screw
M3x30mm
在升降舵预留孔上安装舵角，用环氧胶粘固，并把连杆扣到舵角上。
Installl the rudder horn on the reserved hole of elevator, fix it with
epoxy glue, and fasten the connecting rod to the rudder horn.
04-3
04-4
04-5
04-2
Epoxy glue
如上图在机身内安装舵机，并把连杆另一端与舵机连接，通过快装接头固
定住连杆。
IInstall the servo inside the fuselage as shown in the figure above,
connect the other end of the connecting rod with the servo,and fix
the connecting rod through the EZ-connector.
Epoxy glue
Epoxy glue
卡扣
铝扣
buckle
Alu. buckle
在方向舵控制舵机上，安
装一字型舵臂，两根钢丝
穿入舵臂，调整钢丝连杆
紧绷后，用铝扣锁紧。
Install a straight rudder
arm on the control
steering gear of the
rudder, insert two steel
wires into the rudder
arm, adjust the tension
of the steel wire
connecting rod, and
then lock it with an
机头
aluminum buckle.
airplane head
机头
airplane head
步骤04-2选用小舵机时，可用马达座木片辅助安装。
Step 04-2 When you choose a small servo, use
the wood chip of the motor base to assist in the
installation.
在方向舵的预留孔上安装舵角，用环氧胶粘固。
Install the rudder horn on the reserved hole
of the rudder and fix it with epoxy glue.
方向舵通过两根钢丝拉线与舵
机相连，安装方式见
04-4,04-5,04-6图示。
The rudder is connected to
the servo through two
steel wires, pls refer to the
figure 04-4,04-5,04-6 for
the installation method.
04-6
8