Consort EV1450 Manual - Página 12

Procurar online ou descarregar pdf Manual para Fonte de alimentação Consort EV1450. Consort EV1450 16 páginas.

Imprimir página

End of procedure

The procedure will stop automatically when the timer has reached its end value. A signal will
•
sound during 10 seconds. The sound signal can be ended by pressing a button.
The procedure can also be stopped by pressing /. The power supply will then be in a paused
•
condition. It allows to modify the run parameters and/or to view the gel. When pressing /
again, the power supply will continue the procedure where paused. To stop the procedure
completely, hold  pressed until the main menu appears.
The power supply will remain showing the display of the running condition until the voltage has
•
lowered to a safety value.
When the procedure has finished, a report will be shown on the display. Scroll the display lines
•
with the é ê buttons to see it completely. Press  or / to return to the main menu.

Alarm messages

In case a problem or a hazardous situation is detected, the power supply will intterupt the experiment
with one of the following errors. A sound will also be produced that can be stopped by pressing any key.
The hazardous situations require that the power supply needs to be switched off before starting the
experiment again.
GROUND LEAKAGE
•
A dangerous ground leakage is present (check thoroughly the complete assembly). Your power
supply is NOT defective! See
SHORT-CIRCUIT
•
Connected tank is short-circuited or has a very low resistance (check thoroughly the complete
assembly). Your power supply is NOT defective! See
this manual.
OVERLOAD
•
Connected tank has a too low resistance (check specifications). Your power supply is NOT
defective! See
LOW CURRENT
•
The output current is very low (switch the alarm off in the
NOT defective! See
TECHNICAL PROBLEM
•
Failure in the electronics. See Support on www.consort.be. You could also try a general RESET:
switch the instrument on while holding  pressed. Attention! All stored programs and data will
be erased!

USB Digital Port

This power supply has a digital USB port allowing to interface with a computer. Programs can read and
control the power supply completely. More information can be found on our support website.
Driver
The driver can be downloaded using the link for the USB drivers on our website:
http://www.consort.be/downloads/software/.
Rev. 1605
Frequently Asked Questions
Frequently Asked Questions
Frequently Asked Questions
at the end of this manual.
Frequently Asked Questions
at the end of this manual.
SETUP
at the end of this manual.
Manual Power Supplies
at the end of
menu). Your power supply is
10