AudioPressBox APB-448 SB Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador AudioPressBox APB-448 SB. AudioPressBox APB-448 SB 13 páginas. Press conference audio distribution amplifier

Imprimir página
AudioPressBox APB-448 SB Manual do Proprietário
APB-448 SB - Front panel (Input section)
8
9
10
PFL
Signal
GR[dB]
Clip
6
0
5
-6
-30
2
PAD
+48V
HPF
COMP
4
Out to
3
A
A B
+
B
1
6
11
1) Input XLR microphone/line connector
Input your microphone or line-level source into this
XLR balanced connector. You can connect any type of
condenser either dynamic microphone here.
(1:Ground; 2:Hot, 3:Cold).
2) Phantom power indicator
If the Phantom power is on, this is indicated with solid
red light.
3) +48V button
If you are about to use condenser microphone, turn Phantom
power switch ON to feed your microphone with 24/48V. If you
use dynamic microphone or microphone with his own power,
you can switch this OFF.
7
25
PFL
Signal
GR[dB]
PFL
3
Clip
3
6
6
6
12
0
12
-6
18
18
-30
PAD
+48V
HPF
COMP
PAD
+48V
Out to
A
A B
+
B
CAUTION
When tuning the switch on ( ), be sure that only condenser
mics are connected to the XLR input. Devices other than
condenser mics may be damaged if connected to the phantom
power supply. Note, however, that the switch may be left on
when connecting to balanced dynamic microphones.
To avoid damage to speakers, be sure to turn off amplifiers (or
powered speakers) before turning this switch on or off. We also
recommend that you turn all output controls to their minimum
settings before operating the switch to avoid the risk of loud
noises that could cause hearing loss or device damage.
Signal
GR[dB]
PFL
Signal
GR[dB]
Clip
3
Clip
3
6
6
6
6
0
12
0
12
-6
-6
18
18
-30
-30
HPF
COMP
PAD
+48V
HPF
COMP
ON
Out to
Out to
Hold
A
A
A B
+
A B
+
B
B
Be sure to leave this switch off ( ) if you do not
need phantom power.
13
17
Output
A
B
- 12 -
- 6 -
- 0 -
- -6 -
- -12 -
- -24 -
Volume
- -48 -
Osc
AFL
AFL
Phones
5s
OFF
[dB]
[dB]
12
15
14
16
4) PAD button
If you are using microphone as an input, this button
should be set to "Off" position. If you are using input from
the mixing console or CD player, please set this switch to
"On" position.
5) Input gain level knob
After connecting your microphone, you can set the input
level to reach perfect understanding of lectern's speech.
6) 160 Switch (High Pass Filter)
This button helps to avoid distributing low-end rumble
like a microphone handling noise or pops. You have 2
options – full range or 160Hz low-cut frequency. The one
you choose depends on the sound, you want to filter out.
APB-448SB
Charge
Battery
Power
100%
50%
25%
ON
Low
OFF
19
18
5