Consort SLVT Manual de instalação e controlo - Página 2

Procurar online ou descarregar pdf Manual de instalação e controlo para Controlador de temperatura Consort SLVT. Consort SLVT 4 páginas. Wireless controller

Imprimir página

Please read this guide carefully and retain for future use and maintenance.

SLVT

Do NOT handle the appliance with wet hands.

Do NOT use the appliance in workshops or rooms with high dust

Do NOT leave the appliance unattended where young children

Ensure that nothing is pushed into any aperture of this controller.

Operating temperature range -10 to +40ºC.

1. Getting to know your SLVT wireless controller

The SLVT controller can control an unlimited number of heaters. The controller has 2 operating modes. It has to be

set to the required mode prior to the installation by using the switches located at the back of the controller.

Radio transmit symbol – will

flash every time a signal is sent.

Heating status symbol:

Solid - heating active

not shown - heating inactive

2. Temperature and Timer Mode

For timer mode, the switches are set as shown below.

Controller functionality in timer mode:

In timer mode, the controller acts as a 4 stage run-back timer. When the controller is in stand-by mode and button is

pressed, the first indicator segment will light up green and heating is activated. When pressed again the second segment

will light up and so on. Each segment is representing a time period that is selected when setting the switches.

In the example below, the only switch in the 'ON' position would be number 3. The button would be pressed four times to

activate four 15-minute segments resulting in the heater staying on for 1 hour. At the end of the last time period, the light

indicators will be red for 4 seconds and then go off. The controller is now in stand-by mode.

20 MINS

If the timer mode is not selected, then the user will need to press the ON button again to deactivate the heating.

Wireless

Controller

Do NOT cover or restrict any aperture.

Do NOT use the appliance if damaged.

Temperature not flashing : indicating room temperature

Temperature flashing : indicating set temperature when using UP or DOWN buttons

In timer mode, switch 3 or 4 must be in the 'ON' position. This mode allows for 3 different

settings which will alter the time period for each segment.

Switch 3 - Each time period represents 5 minutes.

Switch 4 - Each time period represents 15 minutes

Switch 3 & 4 - Each time period represents 30 minutes

15 MINS

Installation and User Guide

WARNINGS

exposure.

are present.

10 MINS

5 MINS

Temperature can be

C or F.

This can be changed

by SW1.