Addonics Technologies ST5ESAIUS Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Armazenamento Addonics Technologies ST5ESAIUS. Addonics Technologies ST5ESAIUS 8 páginas. Storage tower

Imprimir página

Tower with USIB connector

Any IDE or ATAPI Storage device can be converted to USB or Firewire

connection via the Addonics USIB interface board and USIB interface cable.

IDE and ATAPI drives must be set as Master device.

USIB back panel

Inside of the USIB back panel

IDE Device Installation to the USIB Connector

IDE drive

IDE ribbon cable

USIB connector

The USIB setup can do hot swap when Addonics mobile racks are used

When using an Addonics mobile rack, make sure that the power from the

USIB board is connected to the power input from the cradle. The power to

the Addonics cradle can only go one way.

For USB2 connection, attach the Addonics USB2.0 USIB interface cable to

the USIB connector.

For Firewire connection, attach the Addonics Firewire USIB interface cable

to the USIB connector.

When non-Addonics mobile rack is used. The Storage Tower can be

powered down and restarted to swap out hard drive without rebooting the

system when using USB or Firewire interface.

To un-mount the drive from the computer using a non-Addonics mobile rack

the USIB cable must be detach from the back of the Storage Tower or the

Storage Tower power must be power off to un-mount the drive from the

computer. The drive will not be hot swappable by turning the switch on and

off from the front of the mobile rack.