AudioSource AMP Two Manual do Proprietário - Página 2
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador AudioSource AMP Two. AudioSource AMP Two 4 páginas. Stereo power amplifier with internal bridging
Também para AudioSource AMP Two: Especificações (2 páginas)
Imprimir página
3
Using the Controls (cont.)
Power Meters
These meters indicate the output level of your AMP Two. When the AMP Two is powered up, the
meters will be softly lit, indicating standby mode. Once the unit's power supply is stabilized, its meters
will brighten completely.
Input Level Controls
These knobs adjust the incoming signal level and thereby act as volume controls. We recommend that these
be set to max and your signal source (receiver, CD player, preamplifier, etc.) be used to adjust the volume.
Manual/Auto Power Switch (Rear Panel)
In the Auto mode, the AMP Two will turn on automatically when an input signal is sensed. In the
absence of an input signal, the AMP Two will shut down automatically. (In the Auto mode, the front panel
power switch should always remain in the on position.) In the Manual mode, use the front panel power
switch to activate the AMP Two.
Hooking up the Wires
Audio signals travel out of one component and into another. All of your connections should also go from out to in.
Line In
2
Connect the line out jacks from your signal source (receiver, CD player, preamplifier, etc.) to the line in
jacks on the AMP Two.
Note: "Line In" and "CD In" jacks cannot be used simultaneously.
Line Out/Thru
3
For a system with multiple amplifiers, a stereo pair of Line Out/Thru jacks sends the original signal
directly to these additional amplifiers.
Bridging Switch (refer to wiring diagram)
In addition to providing 80 watts RMS per channel in the stereo mode, your AMP Two can be used as a
high power mono amplifier, providing over 200 watts RMS. This can be accomplished by sliding the bridging
switch from the stereo position to the mono position. For mono applications, use only the right channel
input. Similarly, use only the right channel input level control.
Note: Be sure to observe the correct speaker connections for bridged applications. Because of the high power output in this
mode, we recommend initially setting the right level control at "min", and then adjusting the volume to the desired level.
Speaker Terminals
More than one pair of speakers can be used with the AMP Two. We have provided two pairs of speaker
outputs, labeled Spkr A (left & right), and Spkr B (left & right). The speaker terminals are color coded. Red
posts indicate positive (+) terminals and black posts indicate negative (–) terminals. Be sure to connect the
positive output terminals of your AMP Two to the positive input terminals of your speakers and the negative
output terminals of your AMP Two to the negative input terminals of your speakers.
Note: Refer to the wiring diagrams on the next page for proper connection of speaker cables.
4
2
1
5
5
1
4