Contacta STS-K072 Manual de instalação e do utilizador - Página 10
Procurar online ou descarregar pdf Manual de instalação e do utilizador para Sistema de microfone Contacta STS-K072. Contacta STS-K072 16 páginas. Window intercom system speaker pod and screen mounted microphone
Também para Contacta STS-K072: Manual de instalação e do utilizador (20 páginas)
Imprimir página
Overview of Front Panel Buttons
Volume In (Customer/Visitor to Staff)
Increase and decrease
Setup
1. Connect all green plugs to the back of the amplifier, following the
locations printed above the sockets (see page 4).
2. Power on the amplifier by pressing the On/Off button.
3. When powered and in normal operational mode the amplifier will display
Volume In LED 1 and Volume Out LED 1 as steady green.
4. When the amplifier is switched off, all audio is muted and none of the
LEDs are illuminated. Pressing any button will turn the amplifier on again.
5. Adjust Volume In and Volume Out to a comfortable level.
6. Press and hold the Volume In (+) or (-) buttons to increase or decrease the
level. The corresponding LED bar will show the volume setting.
6. Ensure the mouse microphones are placed as close to their intended
users as possible.
7. Check the amplifier is fully functional by ensuring the red 'fault' light is
NOT showing on the front.
8. The Amplifier is now set up.
Our Window Intercom System amplifiers are pre-set to volume levels
suitable for nearly all users. Should you need to adjust the Maximum
Volume, Ducking or Hearing Loop levels outside of the pre-set amplifier
parameters, use Engineer's Mode (see page 13).
10
Amplifier Setup
Volume Out (Staff to Customer/Visitor)
Increase and decrease
On/Off
Settings