3xLogic infinias eIDC32 Manual de início rápido - Página 9

Procurar online ou descarregar pdf Manual de início rápido para Porta de entrada 3xLogic infinias eIDC32. 3xLogic infinias eIDC32 17 páginas.

4. Determine the network IP address type: DHCP or static.

WARNING: Do not use DHCP addressing with an expiration time

limit; the DHCP address must be a permanently leased address. A

permanently leased address assigned by the network to the eIDC will

not expire (expiring causes the network to assign the eIDC a different

address, which causes random failures with the eIDC and Supervisor

Plus

that the network is using a permanently leased DHCP address.

a. DHCP: If the following sequence occurs when power is

connected to the eIDC, the network IP address type may or

may not be DHCP.

(1) All LEDs flash three times to begin the sequence. (The

(2) Each numbered LED flashes once representing a number in

(3) Once the sequence has repeated 3 times, the eIDC LEDs

b. Static: If the following sequence occurs when power is

connected to the eIDC, the network IP address type is static:

(1) All of the LEDs flash continuously (more than three times) for

(2) The eIDC reverts to its default static address (169.254.1.1).

5. Go to

installation.

QSG-002 / 01-03-2017

software). Always consult the network administrator to verify

eIDC is fully operational during IP address flashing.)

the IP address. Each grouping of numbers in the address is

separated by all LEDs flashing once, simultaneously.

For example, 145.198.1.1 interprets as follows:

#1 flash, #4 flash, #5 flash, all flash;

#1 flash, #9 flash, #8 flash, all flash;

#1 flash, all flash;

#1 flash, all flash

return to normal operation mode.

approximately 10 seconds. This means a DHCP IP address

cannot be determined or there is no DHCP connection.

NOTE: The default static address can be changed when

the eIDC is configured (refer to

Static IP Mode

Configure the eIDC with the Web Server

Change the eIDC to DHCP or

on page 10).

and complete the