DURASTAR DRPDRAD09F1A17 Manual do proprietário e de instalação - Página 6

Procurar online ou descarregar pdf Manual do proprietário e de instalação para Termostato DURASTAR DRPDRAD09F1A17. DURASTAR DRPDRAD09F1A17 10 páginas. Wired thermostat

Imprimir página

3. In order to prevent water or condensation getting

into the thermostat, make a loop with the wire or

use putty.

Putty

4. Reattach the top panel of the thermostat.

Loop

Putty

Loop

DURASTAR.COM

Connecting The Thermostat

Indoor Unit

Run the 20' lead into the main control box and plug it into the 5-pin wire (labeled with blue tape)

DRAW

coming from port CN2 on the display board. Zip-tie the wire to a secure location.

We recommend using the display panel (DRPDRAD09F1A16), so the unit can be controlled during

service in an attic or crawl space. If using this setup, connect the 20' lead to the 5-pin connector

DRAD

leading to the display panel. Then connect the 10-pin wire from the display panel to port CN10A on

the board. The provided plug adaptor DRPDRAD09F1A17B may need to be used, depending on the

plug size.

Run the 20' lead into the main control box and plug it into the 5-pin wire coming from port CN202 on

DRAS

the display board. Zip-tie the wire to a secure location.

Run the 20' lead into the main control box and plug it into the 5-pin wire coming from port CN2 on the

DRAF

display board. Zip-tie the wire to a secure location.

Run the 20' lead from the thermostat between the panel and the cassette unit. Connect the lead to

DRAC

the female 5- pin wire (labeled with blue tape) that is coming from the unit's panel. Secure the wire

with a zip-tie. This thermostat is not compatible with the DRAC24F1B.

NOTE

• If there is a connection lug at the end of the shielded wire, the connection lug should be

properly grounded.

• Make sure to reserve a length of the lead wire for periodic maintenance.

Connection

DURASTAR.COM