DAPAudio CA-4150 Manual - Página 7

Procurar online ou descarregar pdf Manual para Amplificador DAPAudio CA-4150. DAPAudio CA-4150 16 páginas.

CA-4150

Power Switch ON/OFF

Flick the switch to turn the device on/off.

Power LED

The LED will light in blue when the CA is switched on.

PROT, CLIP, SIGNAL LEDs



PROT: The LED will light in red when the amplifier is in protection mode. Switch off the device and

find out what the problem is. The amplifier is protected against overheating, overload, short

circuit, etc. Decrease the source signal level and/or improve air circulation in the room where

the CA is installed.



CLIP: When the LED lights in red, it indicates distortion. In this case, decrease your source signal

level until the LED turns off. Please keep in mind that the amplifier itself cannot correct any

distortion.



SIGNAL: When the LED lights in green, it means that the CA is operating within its safety limits.

Gain controls (CH A/B)

Turn the controls to set the corresponding channel's gain level.

Gain controls SUB (CH C/D)

Turn the controls to set the corresponding channel's gain level.

Air intake grill

Backside

Euroblock balanced IN

Euroblock balanced inputs for CH A/D.

Cutoff frequency selectors

Cutoff frequency selectors for hi-pass (CH A/B) and low-pass (CH C/D) filters. The adjustment range

is between 50-250Hz.

Mode selector (DIP switches)

Flip the switches on/off to set one of the 9 available modes. See page 7 for more information.

Euroblock CH A/B speaker OUT

Connect the device to speakers. The upper and lower outputs have the same function.

Euroblock CH C speaker OUT

Connect the device to speakers. The upper and lower outputs have the same function.

Euroblock CH D speaker OUT

Connect the device to speakers. The upper and lower outputs have the same function.

Air exhaust

Do not block the air exhaust as it may cause overheating and/or other serious damage.

210-240V AC, IEC power connector IN + Fuse T5AL/250V

Ordercode: D4512

Fig. 02