Duratech TS-1564 Manual - Página 2
Procurar online ou descarregar pdf Manual para Pistola de soldar Duratech TS-1564. Duratech TS-1564 2 páginas. 48w temperature controlled soldering station
Imprimir páginaMAINTENANCE
The Temperature Controlled Soldering Station must be placed on the stand when not in
use.
If the supply cord is damaged in anyway it must be replaced immediately in order to avoid
a hazard. A suitably qualified person or service agent must carry this out.
TIP REPLACEMENT AND DRESSING
Note: Tip replacement or cleaning should be done only when the iron is at room
temperature. The tip can be changed or replaced simply by unscrewing the knurled nut
barrel assembly. It is essential that the station be switched off and allowed to cool before
and during this operation, as damage may result if the system is left on without the tip
inserted. After removing the tip, blow out any oxide dust that may have formed in the tip
retaining area of the barrel. Care should be exercised to avoid getting dust in your eyes.
Replace the tip and tighten the knurled nut barrel assembly using only hand pressure.
Pliers should only be used to tighten the nut, if loosening occurs when the iron is hot. Care
should be taken not to over tighten the nut, as this may damage the element.
GENERAL CLEANING
The outer case of the iron or station may be cleaned with a damp cloth using small
amounts of liquid detergent. Never submerse the unit in liquid or allow any liquid to enter
the case of the station. Never use solvents to clean the case.