DAPAudio D145182B Manual - Página 8

Procurar online ou descarregar pdf Manual para Microfone DAPAudio D145182B. DAPAudio D145182B 13 páginas.

Changing the frequency of the transmitter

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE. After a second, the display

shows the actual frequency while the MHz symbol blinks.

2) Use the up(3) and down(2) buttons to select the desired frequency.

3) Press the set(1) button again to store the setting. The display will briefly show STORE. Now the setting is

stored in memory.

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE. After a second, the display

shows the actual frequency while the MHz symbol blinks.

2) Tap the set(1) button until the display shows SENSIT.

2) Use the up(3) and down(2) buttons to select the sensitivity.

3) Press the set(1) button again to store the setting. The display will briefly show STORE. Now the setting is

stored in memory.

The EM-193B has a locking function. When activated, the locking function blocks all keys so you can't

accidentally switch the EB-16 off or change the frequency while performing.

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE.

2) Tap the set(1) button until the display shows LOC OFF.

3) Press the up(3) buttonto turn the lock function on.

4) Press the set(1) button again. The display will briefly show STORE. Now the setting is stored in memory.

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE.

2) Tap the set(1) button again until the display shows LOC ON.

3) Press the down(2) button to turn the lock function on.

4) Press the set(1) button again. The display will briefly show STORE. Now the setting is stored in memory.

 Make sure you can always see a receiver antenna from the transmitter position.

 Keep the distance from transmitter to receiver antenna as short as possible.

 Point the receiver antennas away from each other at 45 degrees angle from vertical position.

 Avoid placing the receiver antennas near metal surfaces and obstructions.

 Replace battery as soon as low battery LED lights.

 If stacking or rack mounting receivers in a multiple system setup. Do not allow antennas to cross.



Perform a walk-through before performance or presentation. If dead spots are found, adjust the

location of the receiver. If dead spots remain, mark the dead spots and avoid them.