DAPAudio D2181 Manual do produto - Página 10
Procurar online ou descarregar pdf Manual do produto para Equipamento de DJ DAPAudio D2181. DAPAudio D2181 16 páginas.
Imprimir página26. Light BNC Connector
For racklight 12V max. 5W. E.g. DAP D60724, D60725.
27. Booth Control
This control allows you to adjust the volume of the Booth output (43).
28. PFL Split/ Blend Switch
This switch controls the routing to your headphone. In split mode the PFL signal is send to the Left ear
of the headphone connected to the Headphone output (32) the Master signal is send to the Right ear
of the headphone. In Blend mode the PFL and master signal are send to both ears of the headphone.
29. EQ On/ Off
Use this switch to bypass the EQ section.
30. CF Monitor
Use this control to make a headphone mix between your PFL and your master signal.
31. Headphones Volume
This control allows you to adjust the headphones' volume.
32. Headphone
You can connect a pair of headphones with an impedance of 32 - 600 Ohm to the headphones
connector. It is a 6,3mm/ 1/4" TRS socket, wired as Tip=left, Ring=right and sleeve = ground.
Caution: Depending on the type of headphones connected to the Headphones jack, the DS-CM-6 is
capable of producing high output levels via the phones output. Therefore, make sure to turn the
control all the way to the left (minimum setting) before connecting the headphones. Be aware of the
fact that listening to loud sound pressure levels over a longer period of time leads to hearing-
damage!
33. EQ
All 7 frequency bands (60Hz, 250Hz, 1 KHz, 4 KHz, 12 KHz) provide a ±12dB amplification/attenuation.
You can change the overall sound, thus meeting your requirements for different locations. If you want
your sound to have more bass, you have to boost the low frequency range, using the 60Hz or the
250Hz controls. If you experience too much bass, lower the levels of the 60Hz and 250HZ controls. If the
mid-range sounds a bit nasal, try attenuating the 250Hz, 1Khz and 4Khz controls by some decibels. If
you want to have a clear and highly intelligible sound, you should increase the level setting of the
4kHz or 12kHz band a bit. When using the equalizer, less attenuation is better than a great change of
the control settings.
19. Master
You can adjust the output signal to the Master Output (26).
20. Mono/ Stereo Switch
This switch allows you to switch the master output to mono
operation.
21. Balance
Use to set the balance between the Left and right master
output.
22. VU-meter PFL/ Master Switch
This switch assigns the VU-meter to either the PFL-bus or the
master-bus.
23. Power LED
Indicates that the DS-CM-6 is active.
24. Power On / Off
Do not supply power before the whole system is set up and
connected properly.
25. Output Signal VU Meter
This meter is a multi-step LED; respectively the blue LEDs show
-26, -21, -18, -15, -10, -5dB. The red LED shows +0, +3, +6dB. The
accurate level indication allows you to monitor the output signal
level at anytime, and match with other devices.
8