DAPAudio D2184 Manual do produto - Página 9

Procurar online ou descarregar pdf Manual do produto para Equipamento de DJ DAPAudio D2184. DAPAudio D2184 20 páginas.

Installation

Remove all packing materials from the DS-CM-12MP3. Check that all foam and plastic padding is

removed. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

2. MIC 2 Mute

Press this switch to mute the MIC 2 input. The Mute LED will light if the mute function is activated.

3. MIC 1 Mute

Press this switch to mute the MIC 1 input. The Mute LED will light if the mute function is activated.

4/ 5. Mic Channel EQ Treble/ Bass

The Zone's Equalizer section allows shaping of the incoming audio signal. The Mic channel is fitted

with a 2-band EQ. The Treble (4) and Bass (5) shelving controls have their frequencies fixed at

10 Khz and 100 Hz respectively. The treble band has up to 15 dB cut and up to 12 dB boost. The bass

band has up to 23dB cut and up to 12 dB boost.

6. MIC 1 Level

Controls the volume of the Mic 1 (1) input.

7. MIC 2 Level

Controls the volume of the Mic 2 (70) input.

Fig. 4

1. MIC

Electronically balanced XLR-type input for

connecting low impedance microphone. The

input has exremely low noise hum. When

connecting a microphone make sure that the

pin assignment is correct. Always make sure to

read the manual of the microphone you want to

connect. The XLR- input is not suitable for

connecting an additional mixing console, FX- unit,

etc. You have to use the LINE-inputs, when

connecting this kind of equipment.

Note: When connecting signal sources, please

make sure that the corresponding channel faders

and the master faders are at their minimum

settings. Otherwise, unpleasant plug-in noise can

occur.