Duratool 22-13810 Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Perfurar Duratool 22-13810. Duratool 22-13810 8 páginas. 18v cordless drill

Torque

This tool has an adjustable clotch set by the torque setting ring. IF set correctly, the

clutch will disengage the fastening bit at the preset torque setting. The selection

should be based on the size of the screw and the type of mattering being used. If in

doubt, start at the lowest setting and work your way up.

Changing Drill/Driver Bit

Hold the rear chuck collar with one hand and twist the front collar with the other

hand to tighten or undo the chuck.

Ensure that the bit sits straight and securely centered in the middle of the chuck.

Gear Selector (LO/HI)

Set the desired gear using the gear selector (3) on the top of the drill.

Operation

This tool is started and stopped by squeezing and releasing the power trigger (4).

The drill is equipped with variable speed control, which makes it more versatile for a

wide variety of fastening and drilling jobs. The firmer the trigger is squeezed, the

greater the speed of the bit. The lighter the trigger is squeezed, the bit spins slower

for greater control.

Note: After working for a long time at low speeds, it is recommended to give the tool

a short break, and/or run at maximum speed with no load for up to 3 minutes to cool

down the motor.

Drilling Tips and Advice



When drilling into slippery materials, like tiles, try placing a strong piece of

tape on the area in which you are drilling to minimize drill bit walking.



When drilling into metal, use a center punch to make a small indentation

where you wish to drill. This, too, keeps the bit from walking.