DAQ system NET-AIO12 Manual do utilizador - Página 15

Procurar online ou descarregar pdf Manual do utilizador para Placa PCI DAQ system NET-AIO12. DAQ system NET-AIO12 18 páginas.

Imprimir página
8
Data Read Rate
9
AD Data Rate
10
Buffering WR Pointer
11
Buffering RD Pointer
12
View Scale
13
Offset
14
Set
ADC Sampling Rate
15
Sample Rate
16
Set
ADC Config.
17
Channel Selection
ADC Range
18
Selection
19
Set
Digital Input/Output
Digital Input/Output
20
Set
Digital Input/Output
21
Get
ETHERNET INFORMATION
22
IP Address
23
MAC Address
24
SUB-NET MASK
25
GATE WAY
26
Port Number
27
PROGRAM
RAM LOAD/FND
28
RAM LOAD
Displays the number of bytes of data received from the board
AD data received from the board displays the number of
bytes
Displays the library buffer storage pointer.
Display library buffer read pointer.
This is the data reduction factor to be displayed on the graph
when the amplitude of the collected data is large and cannot
be displayed on the graph. When entering "10", the collected
data amplitude is multiplied by 1/10 and displayed on the
graph.
It is an offset to change the upper and lower positions to be
displayed on the Y-axis of the graph. The input value is
summed with the collected data value and displayed on the
graph.
Apply View Scale and Offset to the graph.
Enter the analog data sampling rate. (256~230,000)
Set the sampling rate.
Select ADC channels 1 ~ 6.
Select ADC Range from ±5/±10. Perform 16-Bit conversion for
the selected input range.
Input digital output value.
Set digital output value.
Check 7-Bit digital input value.
Enter the IP address to be saved on the board.
Enter the MAC information to be saved on the board.
Enter the MASKING information to be saved on the board.
Enter the network gateway address to be saved on the board.
Enter the port number to be saved on the board.
Saves items 22~26 to flash memory.
The stored information is reflected in the firmware when the
board is reset, and be careful not to cause a conflict with the
same information setting. This function is information used
only in the Ethernet interface, and this save function is used in
the state that 1) is changed to "USB" and 5) is executed.
Load the USB boot binary in the right editor path to the
NET-AIO12 User's Manual
14