Duratuf KIWI MK2A Manual de instruções de montagem - Página 5

Procurar online ou descarregar pdf Manual de instruções de montagem para Armazenamento ao ar livre Duratuf KIWI MK2A. Duratuf KIWI MK2A 16 páginas.
Também para Duratuf KIWI MK2A: Manual de instruções de montagem (18 páginas)

Imprimir página

Duratuf KIWI MK2A Manual de instruções de montagem

Note:

If fitting a window, there will be no centre stud on the window side. Instead nail in a full length Nog (2.455)

using window studs (.883) to get correct height. Position one window stud centrally beneath the Nog and nail

in place. Further window studs and Nogs are fitted after the cladding is on.

Step 1: Back Wall: Select one 2.545m Base Plate

(Green), one 2.545m Top Plate (Red) and three

Studs (Yellow). Lay out Plates and two Studs on

a flat surface and nail together using two 75mm

nails per join. Nail in remaining centre stud using

1.205m Nogs to get correct position. Position

Nogs .883m from Top Plate and nail in place.

Step 2: Front Wall: Select one 2.545m Base Plate

(Green), one 2.545m Top Plate (Red), four

Studs (Yellow) and two .785m Nogs. Nail studs

to each end of Plates. Nail in remaining two

studs using .785m Nogs to get correct position.

Position Nogs .883m from Top Plate and nail in

place.

Step 3: Select two 2.545m Base Plates (Green) and two

2.545m Top Plates (Red). With front wall lying on

the ground, nail Plates to frame. Ensure Green

joins to Green and Red joins to Red.

Step 4: Position the back wall frame on top of plates.

While someone supports frame, nail in place.

Nail in centre Stud using 1.205m End Wall Nogs

to get correct position.

Step 5: Carefully roll frame over onto its base. (Pieces of

timber from the packaging may be used to tem-

porarily brace the frame before rolling it over).

Position 1.205m End Wall Nogs .883m from Top

Plate and nail in place. If fitting a Kiwi Floor, fit

Floor Joists now. Space joists equally and nail in

place using three 75mm nails per end.

Step 6: Position a Jack Stud on each end of Ridge

Beam and nail in place using two 75mm nails

each end (fig. 1). Turnover Ridge Beam / Jack

Studs, position centrally on 2.545m Top Plates

and nail to Top Plates using two 75mm nails

per Jack Stud.

MK2A TIMBER FRAME