Contemporary Research ICE-HE-DXL Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Amplificador Contemporary Research ICE-HE-DXL. Contemporary Research ICE-HE-DXL 19 páginas. Display control center
Também para Contemporary Research ICE-HE-DXL: Manual de instalação (11 páginas)

Imprimir página
Factory Defaults are shown in Bold.
System
2400 | 4800 | 9600 | 19200 | 38400 | 115K
USB and DB9.
Baud Rate
None | Setup Press setup and right arrow key to temporarily unlock.
Pnl Lockout
Backlight
Display brightness 1-10 (9)
LCD Contrst
Contrast 1-9 (5)
14-45 in 1 dB steps (29). Use 29 when combining with QMODs, 14
RF Level dB
when connecting to QCA9-33 Low RF Input.
Confirm: N | Confirm: Y Restores factory default settings.
Fact Dfault
Displayed as ICE-HE-DXL<X.YY> L/R arrows may be used to view boot-
Firmware
loader and board rev.
Network
IP Address
192.168.1.251
Static | DHCP Note: Changing IP address, gateway, & subnet are not
permitted in DHCP Mode.
IP Mode
Gateway
0.0.0.0
Subnet Mask
255.255.255.0
IP Port
23
MAC/SN
00:14:C8:10:xx:xx
Command
Power
All:On | All:Off
Volume
All:Mute |All:Low | All:Medium
Zn: ALL,01-15 Un: ALL,001-255 Ty: 1-99(21)
(IR Type)
Send IR Type
Zn: ALL,01-15 Un: ALL,001-255 Ty: 1-99(21)
Send 232 Typ
(RS-232 Type)
Note: In the version of firmware available at this time, the "Send 232 Typ" command is supported only with the ICC2-ATSC 4S Tuner/
Controller. It is not yet functional with the ICC1-232 Controller.
Send IR Type / Send 232 Typ Commands
In the Command section of the menu above, Send IR Type and Send 232 Typ are used to match the controllers to the specific TV
models and location on the network. There are three parts to the command, selected by moving the Left/Right arrows to each
value, then using the Up/Down arrows to set a number. Press SELECT to store the changes.
The following is a description of those commands.
All ICC-Net controllers have a display ID that is made up of two values: Zone and Unit. The displays are organized into 16 Zones of
255 displays each. The display number is equal to the Zone number plus the Unit number. For example: Display 258 is Unit 2 (2)
of Zone 1 (256).
Page 8
This setting is for rear
Telnet Port
Zone, Unit, Type
Zone, Unit, Type
ICE-HE-DXL User Manual 04/2018