Contender Baltic Birch Neat-N-Trim C50860 Instruções de montagem - Página 2
Procurar online ou descarregar pdf Instruções de montagem para Mobiliário de interior Contender Baltic Birch Neat-N-Trim C50860. Contender Baltic Birch Neat-N-Trim C50860 2 páginas. Locker
Imprimir página
Step 10: Fit remaining Side Piece over
edge of the assembled pieces, inserting
edges into mortises of Side Piece.
Make sure that back panels fit into back
grooves of Side Piece. Insert hex
screws into pre-drilled holes on Side
Piece and tighten down halfway.
ASSEMBLY INSTRUCTIONS
Step 7: Insert edge of
Short Divider into mortise
of Side Piece, and Center
Shelf. Repeat for remain-
ing Short Dividers.
Step 8: Insert edge of Back Piece into
mortise of Side Piece, and Center
Shelf until edge rests firmly in the
back groove of Bottom Piece.Repeat
for remaining Back Piece.
Step 9: Insert edge of Top Piece into
remaining mortise of the Side Piece.
aligning back grooves. Insert edge of
each divider into the corresponding
mortise on Top Piece. Insert hex
screws into pre-drilled holes of Top
Piece and tighten down halfway.
Step 11: Finish tightening all hex
screws. DO NOT OVER TIGHTEN.
Stand unit upright so that it is resting on
Bottom Piece and the edge of the Side
Pieces. Assembly is complete.