4B M8001V10C Elite Manual de operação - Página 7

Procurar online ou descarregar pdf Manual de operação para Interruptor 4B M8001V10C Elite. 4B M8001V10C Elite 12 páginas. Speed switch

ALL DIMENSIONS IN INCHES

Sensing Face

1-9/16"

The M800 Elite should be wired as shown in the connections diagrams on page 8. The inductive sensing

device, located in the front of the M800 Elite enclosure is designed to detect a metal target on a shaft. The

target can be a bolt head or similar. Ideally, the target should be a ferrous metal but non-ferrous metal

will detect at a shorter range. Maximum range for a ferrous material is 11/32 inches (9 mm) and for non-

ferrous metal is 7/32 inches (6 mm), assuming a 3/4 inch (19 mm) diameter target. Smaller targets may

be used but operating distance will be reduced. The M800 Elite should be mounted adjacent to the target,

ensuring that the distance to the target does not exceed the stated maximum. Typical mounting methods

are shown in fig. 4 (page 9). When mounted against a solid steel shaft, the target or bolt head should

protrude from the shaft about 3/8 inch (10 mm). Otherwise the sensor will not be able to distinguish the

target from the shaft and the red input light would stay on permanently (instead of flashing) and it would

not be possible to calibrate the unit.

TACHO OUTPUT -

An opto-isolated output is provided, rated at 30V 100 mA max. The output is ON when the target is detected

and OFF otherwise. This pulsed output can be used to connect to remote tachometers, PLC inputs, speed

indicators or other electronic products.

O.S.H.A. requires that all exposed rotating shafts are provided with a full guard. Therefore, this device

and its target must be equipped with a guard.

Fasten the M800 Elite to a suitable mounting bracket, such as 4B's Whirligig® universal shaft sensor

mount, with the nose of the switch within the sensing range of the target, as shown below -

DIMENSIONS

Top Side

1-5/32"

WARNING

M800 Elite Shown on Optional

Whirligig® Shaft Sensor Mount with

Mag-Con™ Magnetic Connector

PAGE 7

4-19/32"

2-3/8"

Ø1/4" x 4

1/2" NPT

Conduit Entry

6 ft. Long Cable

8 x 20 AWG Overall

8.3 mm Jacket Diameter