APLICOM A9 IPEX Manual de instalação - Página 5

Procurar online ou descarregar pdf Manual de instalação para GPS APLICOM A9 IPEX. APLICOM A9 IPEX 12 páginas.

Cable installation

The cable is not allowed to bend too tight when installed, see picture above.

Mechanical dimensions are shown below.

Electrical Installation

•

Read warnings chapter on page 7 on this document.

•

Protect power supply lines (6.8...32Vdc) with 3A fuse at power supply end of line.

•

Install the A9 IPEX unit as far away as possible (minimum 1 metres recommended) from the car radio

and its antenna or other electrical devices to avoid any interference.

•

Additional information: Application note K505002 Cabling of Aplicom Products.

•

Avoid ground loops! It is highly recommended to connect all A9 IPEX and peripherals ground

connections to a single point.

•

Disconnecting ground lines shall not be done while the unit is connected to power supply of the vehicle.

This will cause voltage leak between IO connections causing possible problems in external devices

connected to them.

Note! Install the A9 IPEX unit as far away as possible

(minimum 1 metres recommended) from the car radio and

its antenna or other electrical devices to avoid any

interference.

Note! If the ACC option is used, make sure that

mechanical installation is proper. Otherwise ACC results

are not reliable.

Note! Avoid extreme torque when installing the unit. Max

2 Nm.

Note! Install only on flat surface or cover could damage

and IP67 protection could break down.