Aplisens PM-22 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Transdutor Aplisens PM-22. Aplisens PM-22 5 páginas. Intersystem pressure transducer

02.E.002

The transmitter should be mounted using the clamping ring, in a way that protects process connection against

the moisture penetration.

The pressure signal fed is via a flexible plastic Ø6x1 tube.

Electrical connections should be in accordance with fig.1b.

It is recommended to use twisted pair cabling for the signal lines. If electromagnetic interference is

expected, twisted screened cable should be used.

Avoid routing cables with other electrical cables (with inductive load, etc.) or near large electrical

equipment.

7. CALIBRATION

Using potentiometers "zero" and "span" point can be calibrated up to the 10% of the value without interaction

settings.

In the standard version access to the potentiometers is located under a rubber stopper at the top of

the transmitter housing. In special version access to the potentiometers is achieved by unscrewing

the electrical connector.

8. USING

The transmitter, process connector and impulse tubes protect from damage, control their condition.

Protect the transmitter installation against dusts, liquids and aggressive substances.

Every 2 years, or in accordance with the provisions of the applicable user, check and correct

characteristic.

The transmitters should be stored in accordance with the conditions of section 4.3.

9. WARRANTY

Manufacturer warrants to the conditions specified in the Product Certificate which is also a guarantee card.

SCRAPPING, DISPOSAL

10.

Waste or damaged transmitters should be dismantled and disposed of in accordance with Directive

(2012/19/EC) on waste electrical and electronic equipment (WEEE) or returned to the manufacturer.

11. FIGURES

Fig.1a. Intersystem pressure transmitter type PM-22.

Fig.1b. Electrical connection of the PM-22 transmitter

IO.PM-22.01(ENG)