APlusLift HW-10KBP Manual de instalação e operação - Página 5

Procurar online ou descarregar pdf Manual de instalação e operação para Sistemas de elevação APlusLift HW-10KBP. APlusLift HW-10KBP 20 páginas. 2-post floor plate car lift 10,000lb capacity
Também para APlusLift HW-10KBP: Manual de instalação e instruções de funcionamento (16 páginas), Manual de instalação e operação (20 páginas)

 Check the following diagram for the footprint of columns with anchor bolts positions.

 Use a concrete rotary hammer drill with 3/4" drill bit. Do not use excessively worn or

incorrectly sharpened drill bits.

 Keep the drill in a perpendicular position when drilling. Let the drill do the work. Do not

apply excessive pressure.

 Lift the drill up occasionally and clean residue in the hole.

 Drill the holes 1" deeper than the length of the anchor bolts. Drill through the concrete

is recommended (when you move the lift to a new location, you may hammer down the

anchor bolts instead of cutting them off).

 For better holding, power blow dust from the hole.

 Place a flat washer and hex nut over threaded end of anchor, leaving approximately

1/2" of thread exposed. Carefully tap anchor. Do not damage threads. Tap anchor into

the concrete until nut and flat washer are against base plate. Do not use an impact

wrench to tighten. Tighten the nut two or three turns after the concrete is cured (28 day

minimum cure). If the concrete is very hard, tighten only one or two turns.

Anchoring Tips