APlusLift HW-10KBP Manual de instalação e operação - Página 14

Procurar online ou descarregar pdf Manual de instalação e operação para Sistemas de elevação APlusLift HW-10KBP. APlusLift HW-10KBP 20 páginas. 2-post floor plate car lift 10,000lb capacity
Também para APlusLift HW-10KBP: Manual de instalação e instruções de funcionamento (16 páginas), Manual de instalação e operação (20 páginas)

Only authorized personnel can operate the lift. Please read operating and safety

procedures carefully before operating the lift.

 Maintain and inspect lift in accordance with the owner's manual. Never exceed the

capacity.

 Do not operate a lift that is damaged or in need of repair.

 Allow only authorized persons in the lift area.

 Keep the lift area clear when raising or lowering the lift. NO RIDERS.

 Keep hands and feet away from pinch points at all times.

 Never override the lift's operating and safety controls.

 If a vehicle is suspected of falling, clear the area immediately.

 Do not rock the vehicle while positioned on the lift.

 Always use safety jack stands when installing or removing parts from a vehicle.

Vehicle Loading

 Position vehicle at the center of gravity between the pads. Make sure the vehicle is

neither front or rear heavy.

 Place pads at vehicle manufacturer's recommended pick up points. Make sure the

pads are in proper and safe positions to support the vehicle.

 Use caution before lifting pickup trucks, SUVs and other framed vehicles.

 Use truck adapters as needed. Never exceed 9" of pad height.

Raising Lift

 Push up switch to raise lift (make sure arm restraints engage or stop and slightly move

arm to allow gear to mesh) until tires clear the floor.

 Stop and check for secure contact on adapters and vehicle weight distribution. If

secure, raise to your desired height.

 ALWAYS lower the lift into the nearest lock position by pressing the lower lever to

relieve the hydraulic pressure and then let the latch set in a lock position.

 Never work under a lift when the lift is not in a locked position.

Lowering Lift

 Clear all obstacles under the lift to ensure that only the operator is near the lift area.

 Stay clear of lift and raise the lift off the safety locks by 2".

 Pull the safety latch which releases the cable ring one by one on each carriage and

press the lower lever to lower the lift.

 Unload the lift by first completely lowering the lift and then swinging the arms to drive

through position before moving the vehicle.

Operation