APlusLift HW-10KBP Manual de instalação e instruções de funcionamento - Página 10
Procurar online ou descarregar pdf Manual de instalação e instruções de funcionamento para Colunas de elevação APlusLift HW-10KBP. APlusLift HW-10KBP 16 páginas. 2-post floor plate car lift 10,000lb capacity
Também para APlusLift HW-10KBP: Manual de instalação e operação (20 páginas), Manual de instalação e operação (20 páginas)
Imprimir página
INSTALLING SWING ARMS
•
Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over the hole in the carriage torsion
tube. Line up the holes and insert the pin. Repeat for the three other arms.
ELECTRICAL CONNECTION
HAVE A QUALIFIED ELECTRICIAN HOOK THE MAIN ELECTRICAL POWER CONNECTION TO THE
POWER UINT ON THE LIFT. FOLLOW LOCAL CODES IN YOUR AREA.
•
The electricity is to be hooked up at the power unit. This is 220 volt single phase power unit. There is one cluster with three
wires out of motor. Yellow/Green is ground wire. Blue is neutral wire. Brown is live wire. The power supply to the lift
should be 220 Volt with a 30 amp breaker.
•
wire length less than 10mm, wire size is 2.5MM2 / wire length more than 10mm wire size is 4MM2
HYDRAULIC FLUID
•
Remove the vent plug from the top of reservoir. You are going to fill the tank with fluid. Either AW 32 or 46 Hydraulic oil
is good choice. We don't recommend the transmission fluid as it is too thin. The unit will hold approximately 2.64
gallons(10 liters) of fluid.
ADJUSTING CABLES
•
Place a pair of small or medium vise grips around the shoulder of the long threaded adjusting bolt on the cable to
make any adjustments.
•
Use a deep socket to adjust the slack out of the cable. Adjust tension to cables equality.
Figure 5.
10