APlusLift HW-10KOH Manual de instalação e instruções de funcionamento - Página 13
Procurar online ou descarregar pdf Manual de instalação e instruções de funcionamento para Colunas de elevação APlusLift HW-10KOH. APlusLift HW-10KOH 17 páginas. 2-post over head car lift 10,000lb capacity
Também para APlusLift HW-10KOH: Manual de instalação e operação (20 páginas)
Imprimir página
•
Push Up switch to raise lift (make sure arm restraints engage or stop and slightly move arm to allow gear to mesh)
until tires clear floor.
•
Stop and check for secure contact on adapters and vehicle weight distribution. If secure raise to desired height.
•
ALWAYS lower the lift into the nearest lock position by pressing the lower lever to relieve the hydraulic pressure
and let the latch set right in a lock position.
•
Never work under a lift that is not in the locked position.
Lowering Lift
•
Clear all obstacles from under lift and vehicle and ensure only the lift operator is in the lift area.
•
Stay clear of lift and raise the lift off the safety locks by 2".
•
Pull safety latch releases cable ring one by one on each carriage and press the lower lever to begin descent.
•
Unload lift by first completely lowering lift, then swinging arms to drive through position before moving vehicle.
•
•
3.
Maintenance & Safety
MAINTENANCE
Note: IT IS THE CUSTOMER'S OR THE END USER'S RESPONSIBILITY TO MAINTAIN THE PROPER
TENSION ON THE EQUALIZER CABLES. ASKF A QUALIFIED TECHANICAN TO RETURN IN FUTURE
TO MAINTAIN THE CABLE ADJUSTMENT AFTER THE LIFT IS INSTALLED WOULD NOT BE A
WARRANTY FOR THE ADJUSTMENTS.
IF AT ANY TIME YOU'RE NOT SURE TO THE SAFE OPERATION OF THE LIFT, DISCOUNTINUE USING
IT AND CALL YOUR DISTRIBUTOR FOR ASSISTANCE.
Lubrication:
•
Lubricate all Nylon wear block corners inside each column with heavy duty bearing grease before your first operation
and once every six months. Lubricate chains every six months.
Anchor Bolts:
•
During first week of use, check anchor daily. DO NOT use an impact wrench. After first week, check once a month
for the first six months. Tighten if necessary.
Concrete:
•
Check concrete for stress cracks daily for the first two weeks of use as a precaution. Thereafter, check monthly.
Check all bolts and nuts every six months.
Hydraulic Oil:
•
If your lift will raise all the way to the top of the hydraulic tank is full of hydraulic oil. The hydraulic oil should be
changed once a year, along with cleaning the suction filer.
SAFETY LATCH ADJUSTMENT
DO NOT make any adjustment on the lift or cable.
13