Abus Vitess Mortise Manual de serviço - Página 15
Procurar online ou descarregar pdf Manual de serviço para Fechaduras Abus Vitess Mortise. Abus Vitess Mortise 20 páginas.
Imprimir página
ASSEMBLY INSTRUCTIONS - 83 INSERT
Delivery of the pre-loaded housing
•
Our pre-loaded housing includes all parts that are necessary to
assemble a functional cylinder. Inside the cylinder there is a
black plastic plug which has to be exchanged by a pinned core.
•
The housing is filled corresponding to the factory standard with
steel springs and housing pin.
•
In addition, the following parts are included: core retaining
clip, washer, tailpiece and screw.
Step 1
•
Insert the cut key into the cylinder core
•
Place the profile check pin in the core
Step 4
•
Position the pinned core with the inserted
cut key and rotate the core to the 2 o'clock
position
Step 7
•
Fix the protruding side of the tailpiece into
the cutout on the cylinder housing
Step 2
•
Insert the hardened InTop pin into the 1st
chamber
•
Attention: Pull the key a little and insert
it again
Step 5
•
Push the core inside until the plastic plug
has been pushed through completely
•
Rotate the core forward clockwise until the
key is at the 12 o'clock position
Step 8
•
Add the washer to the back of the cylinder
core and fasten the retaining clip
Step 3
•
Insert the bottom pins made of hardened
steel into the 3rd chamber
•
Insert the bottom pins made of nickel silver
into the 2nd and 4th to 6th chamber
Only for master keyed systems: Insert master
wafers
•
Check with cut key – no pin should be
positioned too low or above the shear line
of the core – control with assembly tool
possible
Step 6
•
Remove the key by holding the core with
your thumb
•
The core isn't fixed yet and could be pulled
out with key inside
15