Apogee S2-122 Manual do Proprietário - Página 11

Procurar online ou descarregar pdf Manual do Proprietário para Acessórios Apogee S2-122. Apogee S2-122 16 páginas. Pri sensors

CABLE CONNECTORS

Apogee sensors offer cable connectors to simplify the

process of removing sensors from weather stations

for calibration (the entire cable does not have to be

removed from the station and shipped with the

sensor).

The ruggedized M8 connectors are rated IP68, made

of corrosion-resistant marine-grade stainless-steel,

and designed for extended use in harsh

environmental conditions.

Instructions

Pins and Wiring Colors: All Apogee connectors

have six pins, but not all pins are used for every

sensor. There may also be unused wire colors

inside the cable. To simplify datalogger

connection, we remove the unused pigtail lead

colors at the datalogger end of the cable.

If you ever need a replacement cable, please

pigtail configuration.

Alignment: When reconnecting your sensor,

arrows on the connector jacket and an aligning

notch ensure proper orientation.

Disconnection for extended periods: When

disconnecting the sensor for an extended period

of time from a station, protect the remaining half

of the connector still on the station from water

and dirt with electrical tape or other method.

Tightening: Connectors are designed to be firmly

finger-tightened only. There is an o-ring inside

the connector that can be overly compressed if a

wrench is used. Pay attention to thread

alignment to avoid cross-threading. When fully

tightened, 1-2 threads may still be visible.

WARNING: Do not tighten the connector by

twisting the black cable or sensor head, only twist

the metal connector.

Inline cable connectors are installed 30 cm from the

(pyranometer pictured above)

A reference notch inside the connector ensures

proper alignment before tightening.

When sending sensors in for calibration, only send the

short end of the cable and half the connector.

Finger-tighten firmly

head