4DRC 4D-V30 Manual de Instruções - Página 16
Procurar online ou descarregar pdf Manual de Instruções para Quadricópteros 4DRC 4D-V30. 4DRC 4D-V30 16 páginas.
Correct gesture
Wrong gesture
Correct gesture
Wrong gesture
15.6 MV interface
Click the "filter interface" icon (Figure 18) in the APP control interface, after entering the filter interface,
you can choose to match your favorite filter effect, click the recording icon to start recording (Figure 19.
After the recording is completed, the synthesized short video or picture will be saved to the media library
(Figure 20).
Special prompt: During the recording process, you can rotate the screen or switch the filter effect, and
you can also turn the joystick on / off to control the direction and altitude of the aircraft.
Figure 18
16. FAQ and solving guidelines:
Question
The aircraft indicator flashes
without any response
The blades of the aircraft
rotate but cannot fly
The aircraft vibrates badly
Fine tuning is done but still
can't make the aircraft stable
After the impact, start the
aircraft again and it fly
uncontrollably
Gesture photo: About 2m in front of the aircraft lens, raise the palm
of one hand (palm forward) to a horizontal level on the side of the
body; after the aircraft recognizes the gesture, start a 3-second
countdown and take a photo (the arm can be lowered at this time)
(the time difference between two consecutive recognitions should
be greater than 3s) (some models do not support this function,
turning on the function will cause delay of screen)
Gesture recording: About 2m in front of the aircraft lens, make a fist
with one hand (palm forward) and raise it to a horizontal level on
the side of the body; after the aircraft recognizes the gesture, start
a 3-second countdown and start recording (you can put your arm
down at this time). When the fist gesture is recognized, the
videoing will end. (The palm will not be detected during videoing.)
Figure 19
Reason
The aircraft has insufficient power
1. Low battery
2.1 Blade deformation
2.2 Installation error of AB
propeller
Blade deformation
1. Blade deformation
2. Defective motor
The three-axis acceleration sensor
loses its balance due to impact
15
Figure 20
Solution
Charge the battery
1. Charge the battery
2.1 Replace the blade
2.2 The fan blades are printed with letters
A and B. For fan blade A or B, replace
the one that is broken.
Replace the blade
1. Replace the blade
2. Replace the motor
After leaving the aircraft for 5-10 seconds, or
by the horizontal calibration, it will be ok.
For the steps, please refer to the manual,
10.3 horizontal calibration operation.